Skip to main content
Now through March 1, 2024 we're offering impressive savings on select Fusion Pro Laser Machines! Click HERE for more details.
Home  /  Technical Support  /  Driver Updates  /  Mini/Helix Drivers

Mini 18/24 and Helix

Firmware & Driver Downloads

Signup to receive email notification when a new driver or firmware is available for your laser model.
Mini 18/24 and Helix 24 Tech Specs

Software/Firmware for Mini 18, Mini 24, and Helix 24 systems

Mini/Helix Driver 9.03 (01/07/15)

Replaces version 9.02 (08/25/14)
  • Warning! If you are using DAT files in your driver you must update them with the DAT converter software below.
  • Fix for vector sorting commands sent to Job Manager.
  • Adds support for the Epilog Job Manager.

DAT Converter (08/15/14)

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)
  • Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

  • Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
  • For more information on the Job Manager, click here.

Firmware: 1.0.3.0 (03/10/11)

Replaces 1.0.2.9
  • This release fixes an obscure bug in Mini/Helix systems that caused inconsistent engraving on graphics that were raster only images, but run in Combined mode, with Air Assist enabled at the machine.

Firmware & Driver Downloads



Technical Specifications

Technical specifications for our Mini 18, Mini 24, and Helix 24 systems.