Skip to main content
Home  /  Resources  /  Sample Club  /  Laser Cutting a Guitar Inlay
Sample Club

Laser Cutting a Guitar Inlay



– Laser Cutting a Guitar Inlay
With their incredible precision and accuracy, lasers continue to grow in popularity for inlay/marquetry applications. This sample club features a spider graphic inlaid into a wooden guitar body. The body is made of White Poplar, and the veneer layers – cut from Wenge and Padauk wood – add dimension and contrast to the piece. Read on to learn the steps for laser cutting a guitar inlay!

Project Settings

Materials Needed
Machine Used
Fusion M2 40 120w
Laser Engraving
Laser Vector Cutting
Speed20% Power75% Frequency100%

Prepare Artwork & Material

Open the artwork files and customize as necessary. Apply masking tape to the area of the guitar you plan on engraving, trimming off any excess tape around the edges.

Design files for laser cutting a guitar inlay

Engrave the Veener Pocket

Place the guitar body on to the bed of the laser. In your graphics software, position the spider graphic to align it with where you want it engraved on the guitar. Turn on the red dot pointer at your machine’s control panel, then print the outline of the spider to the laser. Keep the lid to the laser open and watch the red dot pointer trace the outline. Back in your graphics software, adjust the spider graphic as necessary to fit the guitar. Send the spider shape to the laser to engrave the pocket for the veneer inlay. Once complete, remove the masking tape and wipe off any debris around the edges.

engraving the pocket for laser cutting a guitar inlay


Cut the veneer inlay pieces out of the Wenge and Padauk wood. We used the Wenge for the spider body and the Padauk for the hourglass. Peel off the backing and place the veneer in the pocket. Use the roller to make sure the veneer is pressed into position and pressure is applied to the adhesive backing. Inlay the spider body first, then do the same for the hourglass.

laser cutting wood veneer with your epilog


Sand the veneer, lightly, until it is flush with the guitar body. Finish with lacquer, approximately five coats with 30 minutes of dry time between recoating.

sanding the guitar
close up of laser cut guitar inlay
close up of laser engraved and cut guitar inlay

Where can you sell guitars?

  • Local & chain music stores
  • To musicians & instrument collectors
  • In an online store or specialty gift shop

You may also like…

Related to: Wood