FiberMark S2
Firmware & Driver Downloads
Signup to receive email notification when a new driver or firmware is available for your laser model.

Software/Firmware for FiberMark S2 Laser Systems
Software Suite 2.2.5 (2/1/2021)
-
Everything you need to run your FiberMark S2 system
-
Installs the Epilog Job Manager and the Epilog Laser Dashboard
-
For more information on the Job Manager, click here.
-
Download install and use instructions.
Version 2.2.5 Release Notes:
-
Bug fixes and improvements
Minimum Requirements:
-
Please note: Windows 7/8.1/10 is required to use the Epilog Job Manager.
-
Operating system should have all system updates before installation
-
Support for OpenGL 3.0 (or higher) or OpenGL 2.0ES (or higher)
-
4GB RAM or more
-
2 processor cores or more
-
Processor can be any Intel i3/i5/i7, AMD Ryzen 3/5/7, AMD A4/A6/A8/A10/A12/FX
-
Integrated gigabit ethernet required for Fusion M2 vision system. Fusion Pro/Edge does not have the same requirement, but is nice to have.
Recommended Specifications:
-
8GB RAM or more
-
4 processor cores or more
-
Processor can be any Intel i5/i7, AMD Ryzen 5/7, AMD A6/A8/A10/A12/FX
Please note: Remove previous version of Epilog Job Manager and Epilog Software Suite before installation! (Go to Control Panel > Programs and Features and remove the software.)
Firmware: 1.0.1.6 (02/04/11)
Replaces 1.0.1.5
-
This release addresses CE requirements to stop the motion control system if the access door is opened while the machine is operating.
Firmware & Driver Downloads
-
Software Suite 2.2.5: 64 bit (x64)
-
Software Suite 2.2.5: 32 bit (x86)
-
Firmware: 1.0.1.6 (.hex)
-
Firmware: 1.0.1.6 (.zip)
Technical Specifications
Technical specifications for FiberMark S2 system.