Skip to main content
Now through December 15, save $3,000 - $4,000 on our Fusion Galvo G100! Click HERE for more details.
Home  /  Technical Support  /  Driver Updates  /  EXT Drivers

Legend 36EXT

Firmware & Driver Downloads

Signup to receive email notification when a new driver or firmware is available for your laser model.
Legend 36EXT Tech Specs

Software/Firmware for our Legend 36EXT Laser System.

Epilog 36EXT Driver 9.03 (01/07/2015)

Replaces version 9.02 (9/29/2014)
  • Warning! If you are using DAT files in your driver you must update them with the DAT converter software below.
  • Fix for vector sorting commands sent to Job Manager.
  • Adds support for the Epilog Job Manager.

DAT Converter (08/15/14)

First Version for Epilog Zing

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)
  • Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

  • Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
  • For more information on the Job Manager, click here.

Firmware: (02/04/11)

  • This firmware update implements changes to satisfy CE requirements. All laser systems requiring CE certification will be shipped with the Europe option set to Yes. A Yes setting will prevent the carriage from moving and the laser from firing if either interlocked door is open.

32 Bit Driver 8.05 (10/23/09)