Skip to main content
Home  /  Technical Support  /  Driver Updates  /  FiberMark 24 Drivers

FiberMark 24

Firmware & Driver Downloads

Signup to receive email notification when a new driver or firmware is available for your laser model.
FiberMark 24

Software/Firmware for FiberMark 24 Laser System.

FiberMark Driver 9.02 (01/07/2015)

Replaces 9.01 (08/15/2014)
  • Windows 10: You do not need to upgrade your driver when upgrading to Windows 10.
  • Warning: If you have previous DAT files, you will need to use the DAT converter, found below.
  • Fix for vector sorting commands sent to Job Manager.
  • Works with newest version of the Epilog Job Manager.

DAT Converter (08/15/14)

Epilog Job Manager 1.3.6 (01/15/16)

Replaces 1.3.5 (11/23/2015)
  • Improves how the software handles hairline vector lines that extend off the edge of the page. This change only affects the Fusion Laser Series.

Please note: Remove previous version of Epilog Job Manager before installation! (Go to Control Panel > Programs and Features and remove the software.)

Please note: Windows 7/8/10 is required to use the Epilog Job Manager.

  • Warning! Install the driver before the Job Manager to properly associate your driver with the laser.
  • For more information on the Job Manager, click here.

Firmware: (02/04/11)

  • This release addresses CE requirements to stop the motion control system if the access door is opened while the machine is operating.