Custom Gunstock Laser Engraving
Wood
Introduction
Project Settings
Step 1: Position Your Gunstock
Place the wooden gunstock inside your Epilog Laser and position it for engraving. Use the IRIS Camera system to capture a real-time image of the stock. Open a new document in your design software, size it to match your laser’s work area, and import the image to use as a guide for artwork placement.
Step 2: Create Your Design
Crop the image to focus on the engraving area. Using the Bezier tool, trace the section of the gunstock you want to customize. Add the diamond texture pattern behind your outline and remove any portions extending beyond the traced shape.
Step 3: Add Personalized Elements
Incorporate custom artwork, logos, or other design elements. For this project, we added a deer graphic and the Epilog “E” logo. Subtract these elements from the diamond pattern to create a masked effect, leaving the artwork unengraved. Add a hairline outline around the deer for a clean, defined edge. Group your completed design.
Step 4: Set Up Your Engraving Job
Send your artwork to the Epilog Laser Dashboard and confirm its placement using the IRIS Camera. Start with the Wood settings from the Material Library, adjusting as needed for your specific material.
To achieve a deep, textured engraving, enable 3D Engraving under the Advanced tab in the Laser Dashboard. For this project, we ran three engraving cycles to build additional depth and detail.
Step 5: Engrave and Finish
Send the job to your laser and begin engraving. Once all three cycles are complete, remove the gunstock and clean away any remaining engraving residue. The finished piece features a deep diamond texture with crisp, personalized details.

A quick tip: Every type of wood engraves a little differently, so your results may vary depending on the wood species and finish. We recommend testing your settings on a sample piece first and making any adjustments needed to get just the right depth, contrast, and detail.









