Sample Club: Laser Cut Card Design for Mother's Day or Mom's Birthday

Start by inserting the Vector Pin Table into the upper left corner of the machine. We used the vector pin table only on the main portion of the card because it is the only piece that will be seen from the front, and we do not want to have any visible burn marks.

Place the paper on top of the vector pin table and tape it down as necessary.

If you don't have a Vector Pin Table, just raise the paper above the table using small blocks of wood, placing them so the laser won't hit them when cutting through the paper.

After the main portion has been cut, it's time to move on to the decorative accents. Select the letters in the word "MOM" and send only that selection to the laser. Perform this step on two different paper patterns to achieve the shadowed letter look on the front of the card.

The last step prior to assembling the card is to cut the border that runs down the side. Select only the border portion and send that job to the laser.

When you've completed all the steps you should have eight total pieces: main card, border and six letters.