MacBook Engraving

The FiberMark metal marking engraving system also works well on some plastics that are specially engineered to change color when engraved. The Apple MacBook engraves very well with the Epilog FiberMark, changing the white plastic to a stunning black mark.

We've created this fun, geometric design that you can download and engrave on your own MacBook, or use the design with your CO2 laser on an anodized or gray plastic laptop case.

Materials:

Laptop or Notebook Computer

Files: Right click on the file below and choose "Save target as." Open the file in Corel 8 or later. Please note the files for The LionFish Laptop are in raster mode only.

apple_design.cdr

The Epilog system used for this project was a 20 watt FiberMark.

First Open the apple_design.cdr file.
Next measure the dimensions of the laptop you are going to be engraving.
Change the page width and height to the dimensions you collected from your laptop.
Reposition and resize the lionfish graphic if needed.
Note: Be sure to mask off any logos or words you do not want engraved over.

Apple Design File

Setting up the laptop in your Epilog laser system.

Place the laptop into the engraver and use the level to make sure that it is level.

Print settings.

We used the following settings for our engraving:
Speed: 70%
Power: 50%
Frequency: 50

MacBook Engraving

Try using some of your own images or graphics to create a one-of-a-kind laptop.

Let us know what you think of the MacBook Engraving sample.


5 Best	4	3	2	1 Worst

Comments:

Contact Information:

Site Map