Files: Right click the file below and choose "Save target as." Open the file in CorelDraw 8 or later.

The Epilog system used for this project was a 120-watt Legend 36EXT.

• First, remove the small leather extension that comes with the strap.
• Next, apply double-sided tape to the back of the strap and lay it flat on the engraving bed. It's crucial the strap lays flat or the machine will lose focus in areas that are higher or lower.
• Open the file sc_guitar_strap.cdr.
• In CorelDRAW place a vector box around the strap and, with the red dot point on and lid open, send ONLY that job to the laser.
  

• Once you are satisfied with the engraving area, send the job to the laser and you're all set!
• Note: this sample club design was created with a whimsical feel - the notes and patterns are supposed to go off the the engraving area, so don't be concerned if the pattern is slightly larger than your true engraving area.

You'll want to consult your owner's manual for specific
settings, but on a 120-watt Legend 36EXT, we used the following settings: