spacer
 
 
 
Share |


Sample Club: Graduation Photo Frame

Looking for a creative graduation gift? How about a unique frame to hold the graduation photos that you receive? This creative use of a hollow-back plaque allows you to create a frame for different sizes of photos because you cut the hole for the photo with the laser!

Materials:

  • Routed out plaque



graduation photo frame
 

Files: Right click the file below and choose "Save target as." Open the file in CorelDraw 8 or later.

grad_frame.cdr sc_bat_mobile2.cdr


  1)

We purchased the frame for this sample at Colorado Heirloom, a seller of engraveable wood products. You can reach them at 970-667-4222. Any plaque that they sell, you can request to be hollowed out. The picture to the left shows the back of the frame after the hole for the photo has been cut out.

Figure 1
  2)

To the right you can see the file opened in CorelDraw. You can use the photos and quote we chose for this sample, or switch them out with some of your favorites. Use the template to setup your own birthday frames, anniversaries, weddings...any occasion will work!

Figure 2

 

 
 
Share |
 
 
     
   
     
 

Laser Engraving - Laser Cutting - Laser Marking Systems

16371 Table Mountain Parkway · Golden, CO 80403 · USA
sales@epiloglaser.com · +1 (303)277-1188 · toll free (888)437-4564
Fax +1 (303)277-9669 · © Epilog Laser 2009 · Privacy Policy · Choose Your Country



Join our Epilog Fans Page!  

Sitemap