Sample Club: Christmas Countdown Decoration

Materials:

• 1/8" thick sheet of 24 " x 12" Black Acrylic
• 1/8" thick sheet of 24 " x 12" White Acrylic
• 1/8" thick sheet of 24 " x 12" Clear Acrylic
• Roll of 3M double sided stick tape
• Acrylic or Plastic Glue (suggested retailer Acrylic Idea Factory)
• Light Blue Spray Paint
• Heavy Duty Adhesive Velcro 2" (you can find this at most hardware stores)

Files: Right click the file below and choose "Save target as." Open the file in CorelDraw 8 or later.

countdown_file1.cdr	countdown_file2.cdr	countdown_file3.cdr	countdown_guide.cdr

This Merry Christmas Countdown Plaque was created using a 45 watt Mini 24 system.

Start by covering an area of 16" x 12" with tape on the back of the black acrylic sheet (the yellow-orange area pictured to the right in Figure A).

Open the countdown_file1.cdr file and send it to your laser using the appropriate settings for cutting 1/8" acrylic.

Now, prepare the clear sheet of acrylic for cutting by first painting one side with the light blue spray paint (two coats should work).

Once the clear acrylic has finished drying, place the acrylic sheet into the system with the painted side down.

Open the countdown_file2.cdr and send the file to the laser using the appropriate settings.

Note: Use the teeth or non-fuzzy side of velcro for the first part of this step.

Start by covering a 3.75" x 5.75" area on the back side of the white acrylic with the adhesive velcro (corresponding to the blue rectangle in Figure C).

Then cover the rest of area around the velcro with double sided sticky tape (the yellow-orange area pictured in Figure C).

Now place the velcro and tape side face down into your laser system. Open the countdown_file3.cdr and send it to the system using the appropriate settings.

Piece the Merry Christmas Countdown Plaque together using the countdown_guide.cdr file or the steps pictured below and to the right.

Plaque Assembly Steps

1.

2.

Glue the Box Stand together using the guide below.

Step A. Lightly apply glue to the teeth (pictured in red below) of two sides then put the sides together and hold for about 15 to 20 seconds.

Step B. After the glue dries heavily apply more glue to the inside seam of each corner.

Repeat Steps A and B until you have a completed box (pictured to the right ).

Next place double sided sticky tape on the slanted side of the complete Box Stand. (Figure F)

Then stick the box onto the bottom back side of the Merry Christmas Countdown Plaque. (Figure G)

Place the number of days left before Christmas on the front of the plaque, and put the rest of the numbers in the handy storage box attached to the back.

Now you're Done!

Merry Christmas and have a Happy New Year from everyone here at Epilog Laser.