Rotary Center-Center Engraving: When using the Center-Center feature with the Rotary Attachment, raster engraving would be offset in the Y-axis from the intended location. This has been resolved for all Epilog laser systems.
Rotary Auto Focus Position: When using Auto Focus with the Rotary Attachment the table could stall at the very bottom of its stroke. This was seen almost exclusively on the Mini 18, but the issue has been resolved on all Mini, Helix and EXT systems.
The Auto Focus adjustment range has been changed from 0.050” (1.27 mm) to 0.500” (12.7 mm). This change requires both a firmware and driver update.
Adds center-to-center, center-to-top, and center-to-left engraving to the system.
Enhancements to the USB connection make the connection much more robust and easy to set up.
Adds Relocateable X-Axis home position for the Rotary Attachment.
We have implemented a change in the firmware to resolve a problem where the table focus would progressively change position each time a job was repeated.
Version 1.0.0.5: Updated 2/5/07 This is the first version of FiberMark firmware.
Adds center-to-center, center-to-top, and center-to-left engraving to the system.
The Epilog FiberMark require firmware version 1.0.0.8 to work with the new driver.
Version 7.05: Updated 1/26/07
First version of FiberMark driver.
Would you like to be automatically notified when there are new drivers and firmware to be downloaded from our site? Sign up for our Driver Notification mailing list.
