FiberMark Firmware and Driver Downloads

Version: 1.0.1.0 (Replaces 1.0.0.8)

Changes:

• Rotary Center-Center Engraving: When using the Center-Center feature with the Rotary Attachment, raster engraving would be offset in the Y-axis from the intended location. This has been resolved for all Epilog laser systems.
• Rotary Auto Focus Position: When using Auto Focus with the Rotary Attachment the table could stall at the very bottom of its stroke. This was seen almost exclusively on the Mini 18, but the issue has been resolved on all Mini, Helix and EXT systems.
• The Auto Focus adjustment range has been changed from 0.050” (1.27 mm) to 0.500” (12.7 mm). This change requires both a firmware and driver update.

Instructions: Click on the firmware download above and save the file. Normally, the default Save location is onto your Desktop folder.

Once you have the file downloaded, simply double click the file to extract it. You will be asked to save the extracted file to a new location. Select the location you want to save this file to and proceed. Extracting the file changes it from an .exe format to a .hex format. It is the .hex format file that you will use to upgrade.

Print the full instruction files which will walk you step by step through upgrading your system, or read Section 14 in your manual.

Backup: Looking for an older version of our driver? Click here to find recent updates.

Changes:

• The Auto Focus adjustment range has been changed from 0.050” (1.27 mm) to 0.500” (12.7 mm). This change requires both a firmware and driver update.